Item Code: G105600G-A
Last updated: 08-08-2020
A3 FLIGHT CONTROLLER
Equipped with DJI’s advanced A3 Flight Controller, the MG-1S is capable of high levels of reliability. Its algorithm has been optimized for agricultural utilizations,ensuring stable flight even with sloshing liquids. In addition, the redundant design of the A3 includes dual compasses.If an error occurs in one sensor, the system will automatically switch to the other sensor to continue safe, reliable flight.
Three high-precision, microwave radars are placed on the frontslope, rear slope and the bottom of the spray tank. Radars on front andrear slopes detect the terrain, allowing the aircraft to adjust its height approximately. The downward radar then provides high-precision height. As the radars scan, the MG-1S is able to perceive the change of terrain, adjust its altitude and maintain its altitude above the crops.
A new spraying system enables more accurate spraying. With two compatible pumps controlling the front pair and rear pair of nozzles separately,there are now three spraying modes available: forward spraying, backward spraying and full spraying. The new pressure sensor and flow sensor monitor the spraying rate in real-time, realizing dynamic control over spray speed and amount during operation. Nozzles with extended spray booms have beenused to make better use of downward airflows. This spraying system now responds more accurately to commands,adding accuracy and effectiveness to spraying operations.
MG INTELLIGENT OPERATION PLANNING SYSTEM
Plan and edit flight paths intelligently with the MG-1S. When you set the liquid amount for per area, the aircraft will calculate the remaining parameters for you, enhancing convenience. You can also choose between Efficient Mode and Intensive Spraying Mode for different operation needs.
The MG-1S controller includes a bright 5.5 inch/1080p display that is visible even under strong sunlight. With a built-in operation planning system, users can use the controller to increase working efficiency. The battery of controller supports a working time up to 5 hours, enabling long-time outdoor operations.* Data shown in the picture beside is for reference only. Data shown in real operation shall prevail.
|Diagonal Wheelbase||1515 mm|
|Frame Arm Length||625 mm
1471 mm×1471 mm×482 mm（arm unfolded, without propellers）
|Dimensions||1471 mm×1471 mm×482 mm（arm unfolded, without propellers）
780 mm×780 mm×482 mm（arm folded）
|Standard Operating Payload||10 kg|
|Max Battery Size||151 mm×195 mm×70 mm|
|Droplet Size||XR11001VS：130 – 250 μm（subject to working environment and spraying speed）|
|Total Weight||10 kg (without battery)|
|Standard Takeoff Weight||23.8 kg|
|Max Takeoff Weight||24.8 kg (at sea level)|
|Max Thrust-Weight Ratio||1.71 (with 23.8 kg takeoff weight)|
|Power Battery||DJI Designated Battery (MG-12000S)|
|Max Power Consumption||6400 W|
|Hovering Power Consumption||3800 W（@with 23.8 kg takeoff weight）|
|Hovering Time*||22 min（@12000 mAh & 13.8 kg takeoff weight）
10 min（@12000 mAh & 23.8 kg takeoff weight）
*Hovering time acquired at sea level, with wind speeds lower than 3m/s.
|Max Operating Speed||7 m/s|
|Max Flying Speed||12 m/s（P & F Mode，with GPS）；15 m/s （A Mode）|
|Max Service Ceiling Above Sea Level||2000 m|
|Recommended Operating Temperature||0 ℃ to 40 ℃|
|Operating Frequency||2.400 GHz to 2.483 GHz|
|Max Transmission Range||1 km (unobstructed, free of interference)|
|Built-in Battery||9000 mAh，2S LiPo|
|Output Power||7 W|
|Operating Temperature Range||-10 ℃ to 40 ℃|
|Storage Temperature Range||Less than 3 months: -20 to 45℃
More than 3 months: 22 to 28℃
|Charge Temperature Range||5 ℃ to 40 ℃|
|Detection Range||1- 5 m|
|Working Range||1.5 – 3.5 m|
|Precision||< 10 cm|
REMOTE CONTROLLER CHARGER
|Rated Power||57 W|
|Stator Size||60×10 mm|
|Max Thrust||5.1 kg/rotor|
|Max Power||770 W|
|Weight||280g (with cooling fan)|
|Material||High-performance engineered plastics|